Hilti anchors zip tight install#

Use a wire brush to clean the hole, and then vacuum the hole.Clean the hole by using a wire brush, vacuum, or compressed air. Clean the hole of all dust and debris to help ensure proper holding values once the anchor is installed.The retracted position is when the bit is at its most inward position in the chuck. Make sure that when placing the tape on the bit or setting the depth gauge that the bit is in the retracted position.Set the depth gauge on the hammer drill or place tape on the bit at the required depth. Be sure the depth of the hole is correct.Minimum Embedment Depth by Diameter of Wedge Anchor The minimum depth of embedment after the anchor is set is as follows: Make sure that the minimum embedment depth for the diameter of the anchor is met.Drill a hole that is slightly deeper (a minimum of 1/2вЂќ) than the expected embedment depth.Hole tolerance is critical to ensure minimum holding values.Use ANSI standard bits to ensure proper hole tolerance between the hole diameter and anchor diameter.Use an ANSI standard carbide tipped masonry bit, and chuck it into the hammer drill.

Use a bit that is the same diameter of the anchor being installed.

In most cases, this will provide better holding values.

These anchors can be installed at deeper embedments than the minimum embedment depth.

Determine the minimum length of wedge anchor to use by adding the thickness of the material to be fastened to the minimum embedment for the diameter of the anchor to be installed with space for the nut and washer.

Not using a hammer drill will make the hole difficult to drill and may decrease the holding value of the anchor once installed.This ensures proper hole dimensions and makes drilling the hole easier.

Use a hammer drill set in the hammer and rotation mode.

A hammer drill must be used to create the hole in the concrete.

Installing an anchor into concrete can be accomplished by following the directions below. These anchors provide the highest and most consistent holding values of any mechanical type expansion anchor. It is designed for use in solid concrete only. And for that task, a wedge anchor may be the fastener to use.ДЄ wedge anchor is a mechanical type expansion anchor that consists of four parts: the threaded anchor body, the expansion clip, a nut, and a washer.

Hilti anchors zip tight install#

For these tasks and more, youвЂ™ll need to install 2 by 4вЂ™s into the concrete of your basement floor. If youвЂ™re looking to finish your basement, you may wish to start by creating multiple rooms within the space, or installing drywall. ItвЂ™s a project that even first-time homeowners can undertake, and with some instruction and the right materials, they can learn as they go and create a wonderful space for their family. From updating kitchens and installing new floors to finishing basements, one home can house a lot of dreams!ВВДЇinishing the basement is a great DIY project. They are purchasing the home that they dream they can create in their house. When many homeowners purchase their homes, they arenвЂ™t just buying the house as it looks on the day they close on their purchase. Installing a Wedge Anchor: Step by Step Instructions